3D to 2D and Back

This week I was tasked with the challenge of creating three dimensional  objects that can be unfolded into flat nets of the original shapes using the program Rhinoceros. The 10 objects I created can be seen below.

First I started off small with a simple square.

The assignment wasn't necessarily tough. I think it was a little on the tedious side, and because of that, I'd say my main struggle was remembering all the specific tools that I could have used. Overall I'd say I learned a lot, and this became very prominent towards the end of the project where my workflow had increased dramatically as I got more used to working in Rhinoceros.